Frigidaire FGEF300DNB Manuale Utente Scaricare il pdf

30" ELECTRIC RANGE INSTALLATION INSTRUCTIONS

1/8

1. Clearances and Dimensions

a. Provide adequate clearances between the range and adjacent combustible surfaces.

b. Location—Check location where the range will be installed. Check for proper electrical supply and the stability of ﬂ oor.

c. Dimensions that are shown must be used. Given dimensions provide minimum clearance. Contact surface must

be solid and level.

* 30" minimum clearance between the top of the cooking surface

and the bottom of an unprotected wood or metal cabinet; or 24 "

minimum when bottom of wood or metal cabinet is protected by not

less than ¼" ﬂ ame retardant millboard covered with not less than

no. 28 MSG sheet steel, 0.015" stainless steel, 0.024" aluminum

or 0.020" copper. The minimum clearance is 0" for the rear of the

range. Follow all dimension requirements provided above to prevent

property damage, potential ﬁ re hazard, and incorrect countertop

and cabinet cuts.

Avoid locating cabinet storage space above the surface units

to eliminate the possibility of cabinets catching on ﬁ re, or

personal burns from reaching for the cabinets over the heated

units. If cabinet storage is to be provided, risk can be reduced by

installing a range hood that projects horizontally a minimum of

5" beyond the bottom of the cabinets.

Printed in Canada 318201734 (1211) Rev. B

FRONT

VIEW

BACK

VIEW

FRONT

VIEW

TYPICAL CABINET INSTALLATION

SIDE

VIEW

Important Notes to the Installer

1. Read all instructions contained in these installation instructions

before installing the appliance.

2. Remove all packing material before connecting the electrical

supply to the appliance.

3. Observe all governing codes and ordinances.

4. Be sure to leave these instructions with the consumer.

Important Note to the Consumer

Keep these instructions with your Use and Care Guide for future reference.

All dimensions for

electrical outlet

location are maximum.

Cubed area shows

where the electrical

outlet must be

installed for the

range to be ﬂ ush to

the wall.

Wall

Edge

Terminal

Block

Location

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED

INSTALLER. IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S

USE. READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

FOR YOUR SAFETY: Do not store or use gasoline or other

ﬂ ammable vapors and liquids in the vicinity of this or any other appliance.

United States

1 2 3 4 5 6 ... 11 12

Sommario

Pagina 1 - 1. Clearances and Dimensions

130" ELECTRIC RANGE INSTALLATION INSTRUCTIONS1/81. Clearances and Dimensionsa. Provide adequate clearances between the range and adjacent combus

Pagina 2 - 2. Tools You Will Need

4INSTRUCCIONES PARA INSTALACIÓN DE LA ESTUFA ELÉCTRICA DE 30” El riesgo de fuego o de choque eléctrico puede aparecer si usa el tamaño de cable incorr

Pagina 3 - 4. Serial Plate Information

5INSTRUCCIONES PARA INSTALACIÓN DE LA ESTUFA ELÉCTRICA DE 30”Conexión del cable a tres alambres la cocinaSi los códigos locales permiten la conexión d

Pagina 4 - Electrical Shock Hazard

6INSTRUCCIONES PARA INSTALACIÓN DE LA ESTUFA ELÉCTRICA DE 30”NOTA: Asegurese de quitar la banda de puesta a tierra provista.Conexión eléctrica directa

Pagina 5

230" ELECTRIC RANGE INSTALLATION INSTRUCTIONS3. Anti-tip Bracket Installation Instructions Important Safety WarningTo reduce the risk of tipping

Pagina 6 - Before You Call for Service

330" ELECTRIC RANGE INSTALLATION INSTRUCTIONS4. Serial Plate InformationFigure 6 The serial plate is located as shown. See the serial plate for

Pagina 7 - Puerta abre

430" ELECTRIC RANGE INSTALLATION INSTRUCTIONSThis appliance may be connected by means of permanent "hard wiring"; ﬂ exible armored or n

Pagina 8 - (SÓLO MONTAJE EN SUELO)

530" ELECTRIC RANGE INSTALLATION INSTRUCTIONSFour Conductor Wire Connection to RangeWhere local codes does NOT permit connection of the frame gro

Pagina 9 - Deslice la

630" ELECTRIC RANGE INSTALLATION INSTRUCTIONSDirect Electrical Connection to the Circuit Breaker, Fuse Box or Junction BoxIf the appliance is con

Pagina 10 - Juego de cordón de 3 alambres

1INSTRUCCIONES PARA INSTALACIÓN DE LA ESTUFA ELÉCTRICA DE 30”1/8TYPICAL CABINET INSTALLATIONVISTALADO* Un mínimo de 30” de espacio entre la parte supe

Pagina 11

2INSTRUCCIONES PARA INSTALACIÓN DE LA ESTUFA ELÉCTRICA DE 30”2. Herramientas que va a necesitarPara patas de nivelación y montura anti-vuelco:● Llave

Pagina 12 - Antes de llamar al servicio

3INSTRUCCIONES PARA INSTALACIÓN DE LA ESTUFA ELÉCTRICA DE 30”4. Placa de Identiﬁ caciónFigura 3Figura 4Figura 5Figura 6 Esta placa de identiﬁ cación